Remember, this is pure stuff!!===================================
=====================List of chemicals and materials————
——————-Dilute Hydrochloric acid–> This may be purchased
at the hardware store. It’s sold as a brick and driveway cleaner.
They call it muriatic acid. Sodium Hydroxide–> This, you probably
already have. It’s called “lye” at mostplaces; it’s drain cleaner.
Ethyl Ether–> You’ll probably have to make this. Don’t worry,
it’s a breeze. Just go to your local K-mart or Auto parts store,
and get a can of that “STARTING FLUID” it comes in a spray can.
It’s used for cold weather starting of gasoline engines.”VICKS” nasal
inhalers–>USE ONLY VICKS!! No other kind will work that I know of.
These are at any drug store or grocery, etc.. You need 12 of em,
butdon’t buy em’ by the dozen, unless its winter time, then you can
just say yer from some nursing home, and you’re stockin up for the patients.
Otherwise buyem’ 2 at a time, if possible. Get a friend to help you.
The druggists at the drug store usually will know what’s goin on
if you buy quantity.++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++
LIST OF EQUIPMENT
—————– Two large eyedroppers-
ten small glass bottles-
one large glass or porcelainbowl-
coffee filters-
one small jar with a top-
one Pyrex baking dish-
oneglass test tube.———————
———————————————————-
-==*(> N O T I C E DO THIS. OPEN A WINDOW IN THE ROOM IF POSSIBLE. FOLLOW THESE
INSTRUCTIONS EXACTLY. THIS RECIPE HAS BEEN TESTED AND THIS IS
THE BEST WAY TO DO IT. DON’T TAKE SHORTCUTS, AND DON’T EVEN START TO
DO THIS UNLESS YOU HAVE ABOUT 3 HOURS SPARE.—————————
—————————————————-
PREPARING ETHER! (DO THIS FIRST)Take one of the small bottles and
spray starter fluid in it till it lookshalf-full. Then
fill the rest of the way with water, cap the bottle and shake for
5 minutes. Then, draw off the top layer with the eyedropper, and throw
away the water layer. Repeat this until you have about 3 oz. of ether.
Put the cap on it, and put it in the refrigerator if you can.
(If you can’t, don’tworry about it) You’ll use this in the procedure below.
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
THE TRIED AND TRUE HOME PRODUCTION METHOD
(1) Break open the inhalers, a pair of real sharp scissors does this good.
Place the cottons that were inside in a jar and close the lid.
(Remember youuse all 12 cottons.)
(2) In the bowl, combine 1- 1/3 oz. water and 2/3 oz. muriatic acid.
Shred cottons in this solution, and knead for 5 minutes with hands.
(ALWAYS BE SURE THERE’S CLEAN RUBBER GLOVES on your hands.)
You can do it bare-handed if you’vegot tough skin.
Squeeze all juice out of filters after you knead, and throw em away.
(3) Filter the remaining liquid into the quart jar.
It will be necessary to dothis several times to get that awful
smelling oil out. The chemicals in theinhalers have been bonded
to the HCl, and the oils have been filtered off.Throw the filters away.
(4) Pour enough of the solution into a small bottle to fill it 1/3 full.
Saveany leftover juice for the second batch.
(5) Pour 1/4 teaspoon of the lye crystals into the bottle and agitate.
Do thiscarefully, as the mixture will become hot, and give off a gas.
Repeat thisstep until the mixture remains cloudy.
(6) Fill the bottle from step (5) up the rest of the way with ether.
Cap thebottle, and agitate for about 8 minutes.
It is very important to expose everymolecule of the free-base to
the ether for as long as possible.
(7) Let the mixture settle. There will be a middle layer that is very thick.
Tap the side of the bottle to get this layer as thin as possible.
(
Remove the top layer with the eyedropper, being careful not
to get any ofthe middle layer in it. Save the top layer,
and throw the rest away.
(9) Fill a bottle half-way with water, and about 10 drops of acid.
Pour thetop layer from step (
into the bottle, and cap it.
Shake the bottle for 2minutes.
When it settles, remove the top layer and throw it away.
The freebase has now been bonded to the HCl/water mixture.
(10) If there is anything left from step (3), repeat the procedure with it.
(11) Evaporate the solution in the Pyrex dish on low heat.
You can do this onthe stove, but I have found that if you leave it on
top of a hot-water heater (like the one that supplies hot water to your house)
for about 2-3 days, theremaining crystals will be Methamphetamine.
Some notes:Police are now calling this the “New Cocaine”.
It is very easy to become delirious off the ether fumes,
so be sure you arewell ventilated, I mean it!!!
Small, aspirin, or experiment bottles seem to work the best for
smaller batches. The measurements are not exact, so you don’t
have to be either.In step 9, be sure you don’t use too much water.
Remember, this is the water you have to use to evaporate.
